Dryer Vent Hose Replacement in Fountain Hills, AZ

Why does the hose behind my dryer keep crushing?

Because the laundry closet is too shallow for it. Fountain Hills homes often set the dryer tight to drywall. The transition hose folds, kinks, then packs with lint. Push the dryer back and the elbow collapses further. That first turn up from the dryer is where lint cakes hardest. A replacement hose solves nothing if the depth problem stays. We usually swap to a rigid periscope or a short semi-rigid run instead.

The hose is only the connector. It is not the duct in the wall. Long vertical runs to a roof cap are a separate job. So are condo closets venting through shared soffit or sidewall. We check both before touching anything.

Desert dust matters here. Fine grit gets pulled through the laundry room and binds with lint. The result is denser and grittier than humid-climate buildup. Monsoon moisture pasted into a roof cap makes it worse. Plastic caps warp shut from UV, and spring nesting blocks sidewall terminations.

Check it yourself. Pull the dryer out. Look for white dust on the floor. Check for soft spots or a squashed hose. A hot laundry room or burning odor points the same way. So do towels needing two cycles.